Toni 15 posts 0 comments

Relpace your drum unit with a new one. Make sure the machine is turned on. Close the front cover. Press OK and the Up arrow key at the same time. Press OK to select Drum. Press the Up arrow key to reset the drum counter.…

When you replace ti image transfer unit on Konica Minolta bizhub C224e with the new one (I reccomend you to use OEM parts) you must to reset the maintenenance counter. Home, counter (upper left side on the display), Display…

If you get an error code SC551 on your Ricoh copy machine, it means that you have some problem with fuser unit. You can try to reset this error code buth I reccomend you to do this only once. On the keyboard panel, type 8 0 6 1 8 2…

When the machine displays an error code (Call for servise SC-XXX) there is a functional problem with the machine. Sometimes the code can be cleared by turning the machine off for a minute and then powering the machine back up. When powering…

Abnormality in the CCD white reference plate scan level when the scanner lamp is turned ON. Improper installation of the harness to the CCD unit. Dirt on the mirror, lens, and the reference white plate. Scanner lamp lighting trouble.…

This procedure is required when the toner is changed and machine is showing the message “Change the toner cartridge” or “Install toner”, then you must to do this steps: – Open cartridge door, hold invisible # key for 5 seconds, reset…

Make sure that the machine is turned on. Open the front cover. Press and hold OK button about two seconds untill display Drum Unit on the display, and then press OK. Press the Up arrow key to reset the drum counter. Close…

H4-00 error code on Sharp AR-5516, AR-5518 , AR-5520 or AR-5316 (press and hold down 0 key to see the second two numbers from the error on the display) means that the main heater lamp abnormally low temperature detection. You simply…

This error is showing when: - You put out the fuser unit with machine power swich on. - You don't have enough thermal grease in fusing film. - Check the connectors. Reset the code by doing: Additional functions > 2 8 >…

By the service manual, it means 5-time continuous jams of POSD. A fusing jam is not canceled completely. (A jam paper remains.) POSD sensor trouble Fusing unit installation trouble POSD sensor connector and harness connection…